 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Sat Sep 24th, 2005 |
| Location: | Milwaukee, Wisconsin USA |
| Posts: | 16509 |
| Status: |
Offline
|
My Kenmore electric dryer model 110.62212100 is producing no heat.
with the back open - the heating element goes on when the dryer is switched on.
Within 20, 25 seconds I hear a 'click' noise and the element goes off.
Dyer Cabinet nust be a ssmebled for correct air-flow.
re-assembsle the Dryer and try eunning it with the Vent disconnected.
Dryer Vent
Vent should be rigid metal.
Short lengths of flexible metal may be OK, if not crimped when moving the Dryer into place.
NO plastic
NO PVC
NO screws
Foil Duct Tape is OK.
With an empty load, Timed Dry, High Heat,
the vent temperature should cycle somewhere between 135F and 160F
If you have a Harbor Freight Store near you,
click on picture
____________________
The new repair forums==> http://appliantology.org
RegUS_PatOff http://www.youtube.com/watch?v=oPAY2LsKVEw
my video production: “Easter Seals Walk With Me” http://www.youtube.com/watch?v=-EBiLyYXMiA