 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Sun Oct 24th, 2010 |
| Location: | |
| Posts: | 28 |
| Status: |
Offline
|
I wired in the 810. The fridge fired up. After about a minute I pulled the plug and then plugged it back in. After 3 failed starts, I pulled the plug.
(side note: I don't like how this one resets much more quickly than the OEM)
Is it possible that I switched the wires? There were no markings. I measured the resistance of the 3 pins. Bottom two had the most at 7 something, so I figured these are the windings and the top is common.
The left to common had the second most at 4 something so I figured this the run.
The right to common had the least at 3 something, so I figured start.
I thought about reversing the red and white for a trial, but thought it might be wise to check with you guys first.
Also note that the configuration I used matched the one on the 810... but they were careful to call that an illustration only.
Your thoughts?