| View single post by appl.tech.29501 | |||||||||||||
| Posted: Thu Oct 28th, 2010 02:19 am |
|
||||||||||||
appl.tech.29501
|
unplug the unit, disconnect the wires to the heater and OHM it..do the same with the controller or fuse. If both parts show continuity then you will need to ohm the wires to those 2 components individually from inside the freezer to plug on the board. If all that checks out then your board is bad.
____________________ If you would like to make a donation you may do so at the link below http://homepage.mac.com/zenzoidman/appl.tech.29501/ |
||||||||||||
|
| |||||||||||||
