 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Sun Feb 19th, 2006 |
| Location: | |
| Posts: | 10 |
| Status: |
Offline
|
crisis that had to be attended to...now back on the dishwasher trail....
Santa how I wish it was only a malfunctioning pilot light but, the user controls are DEAD no reaction to input...
RegUs...There is power to the controller board (120v) on pins with the heavy white and black wires....3&4 and 10&11 and the single black on pin 8 of J5 at the other end of the board.
Budget...Your idea is simplicity itself....would involve some extra logistics to return items but a solid idea that is being considered.....
I feel that I should run the series of resistance checks on the switch panel....Budgets idea notwithstanding....is there a better test point on the back side of the controller board for the connections to the printed circuit connector to the switch panel??...or
do I have to get out extreme magnification so I can check through the pc foil on the "Ribbon"?
Again all comments and assistance is greatly appreciated.....