View single post by gasgrassorarse
 Posted: Fri Oct 22nd, 2010 05:59 am
PM Quote Reply Full Topic
gasgrassorarse

 

Joined: Mon Oct 18th, 2010
Location: Australia
Posts: 13
Status: 
Offline
 Ok, so I got the pump and the controller board from the 6.5kg installed to the 7.5kg and installed the 2amp fast blow fuse in the power wire at the pump but now I have another problem.

Powered on and it was beeping so I set the board to 7.5kg as instructed, connected the water etc, and put a "test load" on.

The water pulses on and off like the water inlet is faulty.
I placed 20 litres of water into the bowl via bucket and placed it to pump but it doesnt pump out.

Tested at the board socket with multimeter and it shows fine there.

Any ideas??