 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Mon Jul 13th, 2009 |
| Location: | |
| Posts: | 155 |
| Status: |
Offline
|
yes the board is the same you just need to set the size so a change of pump and swap board
you will be lucky to find a 2nd hand board so just swap board and pump over and good to go
To set the size switch turn the power on at the power point and off at the console. Press and hold the
TEMPERATURE UP button then press the POWER button. Smartdrive will give 4 short beeps and the
pattern of LEDs will change.
• Press TEMPERATURE UP button, the COLD LED is on for 5-5.5kg (560mm wide).
• Press WATER LEVEL UP button, the LOW WATER LED is on for 6-6.5kg (600mm wide).
• Press SPIN SPEED UP button, the SPIN HOLD LED is on for 7-7.5kg (650mm wide).
• Press POWER to exit this mode.
sell the other machine on ebay