 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Sat Sep 24th, 2005 |
| Location: | Milwaukee, Wisconsin USA |
| Posts: | 16509 |
| Status: |
Offline
|
Vent should be rigid metal.
Short lengths of flexible metal may be OK, if not crimped when moving the Dryer into place.
NO plastic
NO PVC
NO screws
Foil Duct Tape is OK.
With an empty load, Timed Dry, High Heat, the vent temperature should cycle somewhere between 135F and 160F
Check / clean the Dryer Vent
Disconnect the Dryer Vent and check for good air-flow there and where it exits the house.
Check the Vent air temperature at the back of the Dryer.
If you have a Harbor Freight Store near you,
click on picture $ 4.99 sometimes on sale for $ 2.99
____________________
The new repair forums==> http://appliantology.org
RegUS_PatOff http://www.youtube.com/watch?v=oPAY2LsKVEw
my video production: “Easter Seals Walk With Me” http://www.youtube.com/watch?v=-EBiLyYXMiA