 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Wed Jun 27th, 2007 |
| Location: | |
| Posts: | 27 |
| Status: |
Offline
|
| View single post by mrosec | |||||||||||||
| Posted: Tue Oct 12th, 2010 06:15 pm |
|
||||||||||||
mrosec
|
Okay. Went back and checked connections. All are correct. One was loose. I crimped it down and then tried shorting the two wires on the control board again and the motor started turning, just a few clicks and then it stopped. So, I am guessing the loose wire was the cause of the problem. So, this tells me the push switch is bad, right? Or am I more lost than I think I am?!?
|
||||||||||||
|
| |||||||||||||