View single post by RegUS_PatOff
 Posted: Sat Oct 2nd, 2010 09:16 pm
PM Quote Reply Full Topic
RegUS_PatOff



Joined: Sat Sep 24th, 2005
Location: Milwaukee, Wisconsin USA
Posts: 16509
Status: 
Offline
mrosec wrote: I get a 0ohm reading on the gear motor.  Can I test the raise/lower limit switch?  Would I just test it for continuity? 

are you using a digital OHM meter on the 200 OHM scale ?


Can I test the raise/lower limit switch?  Would I just test it for continuity? 

if you can turn the Gear Motor so that it operates the Switch in both positions ..


No part numbers.  It just says "omron",  "made in Japan", "NC", "NO" and has the numbers 1,2 and 3. 

if you can remove it and check for numbers on the other side..

you could also then check continuity


Do you have a wiring diagram you could scan & upload ?



____________________