View single post by MustLearnSamuraiWay
 Posted: Tue Aug 31st, 2010 06:47 pm
PM Quote Reply Full Topic
MustLearnSamuraiWay

 

Joined: Tue Nov 21st, 2006
Location: Arlington, Massachusetts USA
Posts: 11
Status: 
Offline
 I know you guys can't wait to hear what I'm up to next.

My wife reported that the machine is still not spinning. Surprised, I went down to investigate. This is what I found out: the machine spins for "Quick" or "Touch Up", but not for anything longer, e.g., "Permanent Press", "Normal" or "Heavy". In the longer modes, the machine runs for 6 minutes and then restarts.

Soldering the connector, of course, caused an E48 error -- "board thinks the PTC circuit is closed", which I suppose is the cause of the new trouble -- probably is.

So we'll run "Quick" loads until the latch assembly arrives and take it from there.

Thanks for all your help.