View single post by remnent
 Posted: Thu Aug 26th, 2010 03:33 pm
PM Quote Reply Full Topic
remnent

 

Joined: Tue Aug 24th, 2010
Location:  
Posts: 5
Status: 
Offline
I had taken the motor out while attached to the washer and ran it. It seemed to run without noise or vibration. The motor itself is not rusty, just the underside of the housing and plates. The wiring inside seems to be clean. The biggest problem seems to be (what I assume is) the speed sensor circuit board on the opposite end of the motor shaft. If has a lot of corrosion.

I will send pictures tonight. Thank you for your help.