View single post by elevatorman
 Posted: Sat Apr 23rd, 2005 07:27 pm
PM Quote Reply Full Topic
elevatorman

 

Joined: Sat Apr 23rd, 2005
Location: Georgia USA
Posts: 16
Status: 
Offline
 I just double checked, the pins on the micro are offset so the connector goes on one way. The bracket that holds the micro has a notch for the connector to snap on, it can only go one way also. Can anyone help out with some prints??

I also disconnected the float sw. and put a jumper across the 2 wires on the plug connector~ to check if N.C. would put voltage on water intlet and it tripped the breaker again. I'm wondering now if I should just change the water inlet assy to see if that coil/solenoid is the culprit for smoking the float sw. and tripping the breaker.

Last edited on Sat Apr 23rd, 2005 08:32 pm by elevatorman