View single post by Budget Appliance Repair
 Posted: Sun May 2nd, 2010 10:05 am
PM Quote Reply Full Topic
Budget Appliance Repair

 

Joined: Sat Apr 2nd, 2005
Location: Eureka, California USA
Posts: 2870
Status: 
Offline
jzaz wrote: It is the lower rack (don't need any of the nylon snap on parts - those are fine) for a Maytag MDB4050AWA.

Sounds like when you buy the lower end model you wind up paying the same because you have to replace the rack once or twice.

This model is not particularly quiet either so maybe you also get more insulation on a more expensive model.  As I recall, this was a pretty cheap model.  We purchased it about 12 years ago.

Jzaz, I checked and do have a used rack that is for your dishwasher, it's in perfect condition and comes complete with the center spray tower installed and all moving tine clips in excellent condition, none broken.

If you're interested in it for $50 + whatever it cost to ship let me know.

Post your interest here and I will give you contact info in this discussion if you can't receive PM messages, (you only have 'grasshopper' forum status and I don't think you have use of the PM-Private Message area of the forum).

Last edited on Sun May 2nd, 2010 10:08 am by Budget Appliance Repair



____________________
William Burk (Willie)
Willie's Budget Appliance Repair
Eureka, CA 95501