View single post by SIrgo
 Posted: Mon Apr 19th, 2010 03:55 am
PM Quote Reply Full Topic
SIrgo

 

Joined: Sun Jun 25th, 2006
Location: Hamilton, Ontario Canada
Posts: 4
Status: 
Offline
Did you every get this fixed.  I'm having the same trouble again.  This time i've replaced the  control board and the motor brushes.  Changing the motor brushes seemed to fix the trouble for about 12 loads of laundry but code 03 is back again.  I'm left scratching my head. I suspect its the motor.  When I had the motor apart to replace the brushes I noticed the the spot where the brushes contact the spindle of the motor seemed to be worn pretty good.  Any suggestions?