View single post by RegUS_PatOff
 Posted: Thu Oct 1st, 2009 03:43 am
PM Quote Reply Full Topic
RegUS_PatOff



Joined: Sat Sep 24th, 2005
Location: Milwaukee, Wisconsin USA
Posts: 16509
Status: 
Offline
E9

from a similar manual:

Professional Ranges Models: PDR30/36/48….PGR30/36/48

The control continuously monitors system parameters for control and oven failures
and reports a fault code when a system problem is detected.

The control utilizes the ovens blue “on light” and oven “heating light” to report a detected fault code.

The control will continue to flash the lights in the appropriate sequence as long as the fault exists.

Detection of a fault does not hinder the ability of the control to continue to function if the fault is not critical for the intended operation.

For example: If the range door latch is inoperative, the range will continue to cook
since the fault would only prevent the range from self-cleaning.

ERROR CODE        LIGHT SEQUENCE CODE                   DESCRIPTION

E1                                   22                               EEPROM ERROR            
E2                                   01                               CONTROL NOT CALIBRATED            
E3                                   10                               SENSOR OPEN            
E4                                   12                               SENSOR SHORTED            
E5                                   21                               POTENTIOMETER FAILURE            
E6                                   32                               OVER TEMPERATURE-COOKING            
E7                                   23                               OVER TEMPERATURE-CLEANING             E9                                  43                               NO COOLING FANS            
E11                                 44                               DOOR LATCH FAULT            
E12                                 11                               EXP. BOARD NOT CONNECTED            
E13                                 13                               VCC LIFT OFF ERROR            
E14                                 55                               SELECTOR SWITCH ERROR
 

HOW TO INTERPRET CODES

When a fault occurs, the control will flash the blue oven “on light” and the Blue “heating light” sequentially to indicate the fault.

The fault codes have two numbers, these numbers are interpreted sequentially to indicate the fault.

The fault codes have two numbers, these numbers are interpreted by the number of times the lights flash.

The oven “on light” will flash indicating the first number, by the number of times the lights flash.

The oven “on light” will flash indicating the first number, and the “heating light” will flash indicating the second number.

EXAMPLE: Error E9 is…. No Cooling Fans.  The code is 43.

The oven “on light” will flash four times, then the “heating light” will flash three times, then pause.

The sequence will then pause. The sequence will then repeat as long as the fault is present.



____________________
The new repair forums==> http://appliantology.org

RegUS_PatOff http://www.youtube.com/watch?v=oPAY2LsKVEw

my video production: “Easter Seals Walk With Me” http://www.youtube.com/watch?v=-EBiLyYXMiA