View single post by kdog
 Posted: Mon Sep 21st, 2009 08:42 pm
Full Topic
kdog



Joined: Sun May 8th, 2005
Location: Calgary, Alberta Canada
Posts: 2560
Status: 
Offline
There is also a plastic connector(plug) behind the oven where the sensor leads travel through, if this connector comes in contact with a hot surface it can melt - i will often cut the plastic plugs off and make a good connection by stripping the wiring and securing with a ceramic marette connector - start the oven with the rear panel open and wiggle and tug on the leads while it operates and this may cause the range to go into the failure mode



____________________
Can Ye spare some 'cutter me brutha ?

http://web.me.com/zenzoidman/kdog/