View single post by ijourneaux
 Posted: Mon Sep 21st, 2009 04:50 pm
Full Topic
ijourneaux

 

Joined: Fri Jan 2nd, 2009
Location:  
Posts: 15
Status: 
Offline
We have a Maytag Gemini double oven. A few years back, we got an F1-1 code that was easily fixed by replacing the temperature sensor. A few weeks ago (again after a self-clean cycle) the F1-1 code reappeared. This time unfortuantely replacing the sensor seems to have been only a temporary solution.

The code disappeared for a couple of weeks and then reappeared last week. It went away by itself again and now seems to be working.

Is it possible that the new sensor is bad or do the symptoms point to a failure of the control panel. I am not eager to spend $220 dollars to try fix the oven if I don't have to. If the problem is the control panel, is there anything that can be done to fix it?

Take Care