View single post by kdog
 Posted: Sun Jul 19th, 2009 01:41 am
PM Quote Reply Full Topic
kdog



Joined: Sun May 8th, 2005
Location: Calgary, Alberta Canada
Posts: 2560
Status: 
Offline
If I were you, I would perform some of the diagnostics in the tech sheet that Reg has provided, an ob code could mean off balance- and you refer to the machine bouncing around. Throwing a control board at the machine may solve nothing. Run some of the checks and see what the machine WON'T do.

Afterwards you may wanna clear the failure codes and run the machine again to see what comes up

Last edited on Sun Jul 19th, 2009 01:45 am by kdog



____________________
Can Ye spare some 'cutter me brutha ?

http://web.me.com/zenzoidman/kdog/