 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Mon May 18th, 2009 |
| Location: | Melbourne, Florida USA |
| Posts: | 75 |
| Status: |
Offline
|
We have had two new kenmore friges with the same problem- condensate pan breakage. The first was due to the foam block below the water filter housing being displaced during shipping, and the housing pressing on the tray. The second was due (I think...) to the taping of the tray. There are two pieces of tape holdimg the tray down, one front one back. When these were installed, they were pulled tight enough to cause an upward bow to the tray. This eventually led to the plastic cracking.
Both friges were JUST out of the one year warranty. This fault appeared as a water leak complaint. Any ideas on how to check and see if this is a recall problem? We have several of these friges on property, and I dont look forward to fixing them all as the leaks appear.
IMO, the super thin plastic of the tray is at fault.
Thanks!!
____________________
Onward and Upward!