View single post by rsmigel
 Posted: Sun Jun 14th, 2009 02:50 pm
PM Quote Reply Full Topic
rsmigel

 

Joined: Thu Jan 12th, 2006
Location: Duncan, South Carolina USA
Posts: 30
Status: 
Offline
Thanks again Reg for the quick reply.

There are (3) 1/4" hex head screws holding the assy up; two near the front door pointing upward and one to the right of the water filter pointing to the rear.  Then there are (2) Phillips head screws behind the light bulbs.  After removing those (5) screws, the entire top assembly drops down and the Adaptive Frost Module is easily popped out from the top.

I looked at my old board and the 22uF/50V capacitor is clearly blown.  I'll replace that and use it as a spare.  Radio Shack doesn't carry this exact cap so I'll pick it up on the Bay.

:D