View single post by Sophie
 Posted: Sat Apr 4th, 2009 08:26 pm
PM Quote Reply Full Topic
Sophie

 

Joined: Sat Apr 4th, 2009
Location:  
Posts: 1
Status: 
Offline
I am opening up my Maytag MDB915 lower arm to clean out a severe case of gunk. I have reached as far #12 in the drawing from most wise Sublime Master. I got #11 off, and removed the bolt #12. The bolt seems to have a small black tapered washer that came out along with the bolt. I cannot see a #13, and am not able to remove #14 -- it seems quite solidly attached. #15 and below apparently won't come off until #14 is off.

Any suggestions, oh wise readers, or perhaps even oh Sublime Master, most appreciated.

Also, is it a good idea to soak everything below #14 in CLR for a couple of hours, in case I cannot get them disassembled?

Your humble servant ...