 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Fri Jul 29th, 2005 |
| Location: | |
| Posts: | 32 |
| Status: |
Offline
|
I know, I am just trying to stay out of the mud
The air handler stack is shown as TWE065E130A1 WITH SERIAL M1321WN1V. Shown as 1 HP. I pulled that from the unit itself.
The thermostat says Honeywell Chronotherm III.
I'll throw this in as well....The proposal did not quite agree on model nums. Will furnish on request. It showed 49,000
btu cool and 43,500 heat, variable cfm.
I failed to mention the return placement. One is next to the air handler, less than a couple feet away. Goes to a platform on the floor under the filter insert. The other is near the attic boot just below the ceiling upstairs. They are both large. I switched to the pleated filters during the second year. I am concerned that it was installed with a spun glass cheapo, and I was dumb enough to use the box of them they left behind, so the coil does concern me. but that was 2003 when the unit was fired up.
The outdoor supply lines are in rubber pipe wrap.
All registers are in the ceiling. Hopefully this will give you enough to work with