View single post by ddunk1946
 Posted: Tue Jan 20th, 2009 03:51 am
PM Quote Reply Full Topic
ddunk1946



Joined: Wed Dec 26th, 2007
Location: Sugar Land, Texas USA
Posts: 37
Status: 
Offline
Hiya!

Well, I ran several cleaning cycles through the thing and it didn't change anything. I don't really have any more time to spend on this; have to get it running. I could start replacing $200 modules but I might as well call the local Whirlpool 'stealership' and get the checkbook out.

I've processed a couple of loads by running the appropriate cycle. Of course, during the last 30 seconds or so of the cycle, just as the drum is spinning down, it still coughs up about a half gallon in the drum. BUT, I can run diagnostics and when it complete C:08, the load has spun and is just damp and ready for the dryer. Not an elegant solution but will do until the tech dude (or dudette) gets here.

Thanks for all the help folks!



____________________
Donn Dunkel
Dunkel Kinetics
P.O. Box 16537
Sugar Land, Texas 77496
dadunkel@att.net
donn@sugarlandrealestate.com