View single post by ddunk1946
 Posted: Mon Jan 19th, 2009 10:00 pm
PM Quote Reply Full Topic
ddunk1946



Joined: Wed Dec 26th, 2007
Location: Sugar Land, Texas USA
Posts: 37
Status: 
Offline
Ok, have run the cleaning cycle using bleach and am now on the second cleaning cycle (hot water, extra rinse, no laundry in tub) using Electrosol.

No change yet but have discovered that after the normal cycle, I can run the C:08 diagnostic to spin the clothes damp so they can be dried. No water enters during the C:08 test.

Not the most elegant solution but, hey, it might work for a load or two until we can sort this out, n'cest pas?

Are we sure there's no components that are marginal or would the system give us trouble codes if that were the case? How about the pressure switch? I would hate to have to pull this thing out to check on the other end of the small hose that disappears down the back!

Anyway, later!



____________________
Donn Dunkel
Dunkel Kinetics
P.O. Box 16537
Sugar Land, Texas 77496
dadunkel@att.net
donn@sugarlandrealestate.com