View single post by wesley2anderson
 Posted: Fri Jan 2nd, 2009 09:56 pm
Full Topic
wesley2anderson

 

Joined: Wed Dec 31st, 2008
Location:  
Posts: 3
Status: 
Offline
I also tried using an ohm meter to check the door latch circuitry.  fist it was at 1600 ohms.  I left it plugged in during a spin/drain cycle the ohm meter went negative for the first few min then jumped up to 600 to 800 ohms and at the 7 min mark the washer stopped and the ohm meter stayed at 800 ohms and did not go above 1000 ohms.   I did this on the one with two wires on it and it slid onto two metal prongs coming out of the door latch circuitry.

Does this mean it is the door latch circuitry is bad or did i do this wrong?

Please help my wife is going nuts.

thanks

Last edited on Fri Jan 2nd, 2009 09:57 pm by wesley2anderson