 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Mon Mar 10th, 2008 |
| Location: | Tidewater, Oregon USA |
| Posts: | 1178 |
| Status: |
Offline
|
| View single post by certified tech group 51 | |||||||||||||
| Posted: Thu Dec 25th, 2008 07:35 pm |
|
||||||||||||
certified tech group 51
|
You removed the drive block once before? Yes, remove the plastic piece and the clip ( the nut can stay) and using the picture provided by Reg.U.S., see the two tabs on the spin tube? The drive block has two mating slots that drops down onto the tube..... are you using the correct wrench to tighten the nut? You could have rounded off the corners of the spin tube....
|
||||||||||||
|
| |||||||||||||