View single post by Crickettoo
 Posted: Sat Jul 12th, 2008 09:45 pm
PM Quote Reply Full Topic
Crickettoo

 

Joined: Fri Jul 11th, 2008
Location:  
Posts: 4
Status: 
Offline
Yes. Thanks. That was it!  I realigned the belt out of the groove and it works (although I haven't tried drying any clothes yet, it is tumbling again).  One more small question, and I don't know if it makes a lot of difference.  I didn't pay close enough attention when I removed the small back access panel to get to the pulleys, so didn't recall which way the slats faced - inward/down, outward /down, inward/up, or outward/up.  There are some slats cut into the larger back panel of the dryer and the ones on the lower half face out and down so I went with that. Thanks.