| Author | Post |
|---|
quinntessa
Apprentice Appliantologist
| Joined: | Sun Aug 17th, 2008 |
| Location: | |
| Posts: | 3 |
| Flavorite Brew: | all |
| Status: |
Offline
|
|
Posted: Sun Aug 17th, 2008 15:39 |
|
| I hate the day I purchased this piece of junk, but that aside, going on vacation trying to do laundry, go downstairs to get error code F30, it is obvious that the front loading washer will not spin, from the top I can hear a buzzing sound near the top of the washer. Please help.
|
Appliance Assistant
Master Appliantologist
| Joined: | Sat Mar 29th, 2008 |
| Location: | Vista, California USA |
| Posts: | 56 |
| Flavorite Brew: | stone ipa |
| Status: |
Offline
|
|
Posted: Sun Aug 17th, 2008 16:34 |
|
F30
DISPENSER SYSTEM ERROR ERREUR DU SYSTÈME DE DISTRIBUTION DE PRODUITS
When the dispenser motor cannot be driven to its proper
position.
1. Unplug washer or disconnect power.
2. Check mechanical linkage from dispenser motor to the top
of the dispenser.
3. Check wire harness connections to the dispenser motor
and Central Control Unit (CCU).
4. Check dispenser motor for powered rotations.
Remove the top by removing three screws at the rear of the lid and sliding the top toward the rear of the washer about 1/4 of an inch before lifting.
hope that helps some.
____________________
http://www.applianceassistant.com
|
quinntessa
Apprentice Appliantologist
| Joined: | Sun Aug 17th, 2008 |
| Location: | |
| Posts: | 3 |
| Flavorite Brew: | all |
| Status: |
Offline
|
|
Posted: Sun Aug 17th, 2008 17:35 |
|
| thank you that is exactly what it was and it is up and running!
|
Appliance Assistant
Master Appliantologist
| Joined: | Sat Mar 29th, 2008 |
| Location: | Vista, California USA |
| Posts: | 56 |
| Flavorite Brew: | stone ipa |
| Status: |
Offline
|
|
Posted: Sun Aug 17th, 2008 17:44 |
|
Great! 
____________________
http://www.applianceassistant.com
|
Samurai Appliance Repair Man
Fermented Grand Master of Appliantology
|
Posted: Sun Aug 17th, 2008 21:50 |
|
quinntessa wrote:
1. Unplug washer or disconnect power.
2. Check mechanical linkage from dispenser motor to the top
of the dispenser.
3. Check wire harness connections to the dispenser motor
and Central Control Unit (CCU).
4. Check dispenser motor for powered rotations.
.
.
.
thank you that is exactly what it was and it is up and running!
So, which was the problem: 2, 3, or 4? 
____________________
Love? beer.fixitnow.com
|
quinntessa
Apprentice Appliantologist
| Joined: | Sun Aug 17th, 2008 |
| Location: | |
| Posts: | 3 |
| Flavorite Brew: | all |
| Status: |
Offline
|
|
Posted: Sun Aug 17th, 2008 22:36 |
|
| it was 2
|
Current time is 18:30 | |
|
