Fisher & Paykel DD603 - F3 Error - The Kitchen Appliance Repair Forum - Do-It-Yourself Appliance Repair Help - ApplianceGuru.com: The Samurai Appliance Repair Forums

ApplianceGuru.com: The Samurai Appliance Repair Forums Home

ApplianceGuru.com: The Samurai Appliance Repair Forums > Do-It-Yourself Appliance Repair Help > The Kitchen Appliance Repair Forum > Fisher & Paykel DD603 - F3 Error

Konnichiwa and Welcome!

Please register or watch this short screencast on how to get started here.

SEARCH THIS SITE
We have a bizillion pages of specific appliance repair questions and answers here just aching for the furtive caress of your engorged and tingling eyeballs. Use this search box to find ‘em.

FIND PARTS FAST
Search by part number or model number. You can also search by appliance type, brand, or even the type of part.

Moderated by: RegUS_PatOff, Pegi

New Topic

Printer Friendly

Fisher & Paykel DD603 - F3 Error

Rate Topic

Author	Post

Posted: Fri Jun 26th, 2009 04:17 am

Quote

1^st Post

soda
Apprentice Appliantologist, First Class

Joined:	Thu Jun 25th, 2009
Location:
Posts:	4
Flavorite Brew:	fat tire
Status:	Offline

I have a Fisher & Paykel DD603. Both drawers stopped working with same error, F3. It will run for about 5 minutes then stop with F3 error. Water does not drain and I have to unplug to reset. It is also stuck on the last wash setting, the inside buttons don't change the wash cycle, or eco mode. When wash stops, water is warm but not hot.

Any suggestions on things to check? Is there a common part that will cause both drawers to fail with same conditions?

Thanks!

Quote

Posted: Sat Jul 4th, 2009 06:47 am

Quote

2^nd Post

m_ouwerkerk
Senior Apprentice Appliantologist

Joined:	Fri Jan 30th, 2009
Location:
Posts:	38
Flavorite Brew:	Home brew: Hoegaarden
Status:	Offline

Here are the trouble shooting steps for F3:

F3 Water temperature sensed at greater than 85°C ( 185°F)

1 Is the incoming water temperature greater than 85°C (185°F)

Y: Adjust the incoming water temperature.
N: Go to Question 2

2 Is the element on all the time?

Y: Replace the electronic controller
N: Go to Question 3

3 Are the wiring and connections from the controller to the element all okay?

Y: Go to Question 4
N: Repair or replace wiring harness or wiring connections

4 Are there any signs of moisture around the temperature sensor?

Y: Locate and repair source of leak
N: Go to Question 5

5 Is the resistance of the temperature sensor correct?

Y: Go to Question 6
N: Replace heater plate assembly

6 Does the machine fault again if run through a test cycle?

Y: Go to Question 1
N: No fault found

Quote

Posted: Tue Jul 7th, 2009 07:43 pm

Quote

3^rd Post

soda
Apprentice Appliantologist, First Class

Joined:	Thu Jun 25th, 2009
Location:
Posts:	4
Flavorite Brew:	fat tire
Status:	Offline

Can controller temperature reading be recalibrated?

This is happening on both drawers.

The incoming water temp is about 25C (less than 85C)
The element is on, but the water temp is about 35C when it dishwasher stops with F3 error.

I took apart one drawer there was no moisture around the temp sensor.

The resistance off the circuit board, measured correctly at 20/30/60C. Same resistance was found when measured at controller connector.

Ran a fast test cycle and turned on the temp display mode. The temp displayed was 80C during fill after about 2 minutes, it displayed 85C and stopped with F3 code. Water temp inside tub was 35C.

Temp sensor on 2nd drawer measured correct at controller connector.

I cannot swap controllers because both have the same problem. Temp sensor resistance is good, but controller displaying incorrect water temp.

It appears the controller is converting the temp sensor resistance incorrectly, is this adjustable? Does this indicate the controller is bad?

Quote

Current time is 02:23 pm
ApplianceGuru.com: The Samurai Appliance Repair Forums > Do-It-Yourself Appliance Repair Help > The Kitchen Appliance Repair Forum > Fisher & Paykel DD603 - F3 Error	Top

Your Sometimes-Lucid Host:

"If I can't help you fix your appliance and make you 100% satisfied, I will come to your home and slice open my belly, spilling my steaming entrails onto your floor."