|
FAQs | Parts | Service | Store | Newsletter | Sitemap | Beer | Home |
ApplianceGuru.com: The Samurai Appliance Repair Forums > Do-It-Yourself Appliance Repair Help > The Kitchen Appliance Repair Forum > Magic Chef 31213XAW Gas Range - Two burners spark and two do not... |
Konnichiwa and Welcome!Please register or watch this short screencast on how to get started here.
|
| Moderated by: RegUS_PatOff, Pegi |
|
|
|||||||||||||
| Magic Chef 31213XAW Gas Range - Two burners spark and two do not... | Rate Topic |
| Author | Post |
|---|
| Posted: Fri Apr 24th, 2009 11:22 pm |
|
1st Post |
|
cfr Grasshopper
|
So I'm trying to help my neighbor fix her stove. It's a Magic Chef\Maytag with the sealed burners. When I try any of the four knobs, I only get spark on the back two burners. I'm getting gas from all four burners. What part(s) do I need to focus on changing? I don't know if it's the spark module or the ignitor. Any help would br greatly appreciated... Thanks, Chris
|
||||||||||||||
| |||||||||||||||
| Posted: Sat Apr 25th, 2009 03:53 am |
|
2nd Post |
|
hvacdrd Fellow, Academy of Sublime Masters of Appliantology 
|
You can check the ignitors/wiring by switching the output wires at the spark module. If the front ones work & back ones stop working, change out the module. If no change take a look at the ignitor(remove screw on bottom to remove ignitor), ignitor wire & ground wire by removing the burners. click on pics Spark module  Burner/ignitor 
____________________ Tip Jar |
|||||||||||||
| ||||||||||||||
| Posted: Sat Apr 25th, 2009 09:46 am |
|
3rd Post |
|
RegUS_PatOff Fellow, Academy of Sublime Masters of Appliantology 
|
did it work OK up until now ? any changes / re-installation, etc ?
____________________ RegUS_PatOff http://www.youtube.com/watch?v=oPAY2LsKVEw my video production: “Easter Seals Walk With Me” (also in HQ) http://www.youtube.com/watch?v=-EBiLyYXMiA Upon leaving this Earth "Do you want the Smoking or Non-Smoking section ?" |
||||||||||||||
| |||||||||||||||
| Posted: Sat Apr 25th, 2009 06:38 pm |
|
4th Post |
|
cfr Grasshopper
|
I guess they haven't been working for her for a while.... I will try switching wires on the spark module. I guess that is accessed form the back of the unit?
|
|||||||||||||
| ||||||||||||||
| Posted: Sat Apr 25th, 2009 06:54 pm |
|
5th Post |
|
RegUS_PatOff Fellow, Academy of Sublime Masters of Appliantology
|
"The spark module is located on the lower right side base rail as veiwed from the front of the unit. Remove the top and side panel. Remove three screws from the rear and top edges of the side panel. This should loosen the side panel enough to pull up and disengage the “key hole" at the front inside of the panel (top & bottom) from the screw and plastic spacer holding it in place." 31213XAW Service Manual Last edited on Sat Apr 25th, 2009 06:56 pm by RegUS_PatOff ____________________ RegUS_PatOff http://www.youtube.com/watch?v=oPAY2LsKVEw my video production: “Easter Seals Walk With Me” (also in HQ) http://www.youtube.com/watch?v=-EBiLyYXMiA Upon leaving this Earth "Do you want the Smoking or Non-Smoking section ?" |
||||||||||||||
| |||||||||||||||
| Posted: Thu Apr 30th, 2009 06:41 am |
|
6th Post |
|
cfr Grasshopper
|
Thanks for the advise especially the service manual. It was easier than I thought. The spark module was the issue. Thanks again... Chris
|
|||||||||||||
| ||||||||||||||
| Current time is 12:11 pm | |
| ApplianceGuru.com: The Samurai Appliance Repair Forums > Do-It-Yourself Appliance Repair Help > The Kitchen Appliance Repair Forum > Magic Chef 31213XAW Gas Range - Two burners spark and two do not... | Top |
FAQs | Parts | Service | Store | Newsletter | Sitemap | Beer | Home
